RE: Reuse B/RB intake Gasket?

[Steven Charette <stevec@xxxxxxxxxxxxxxxxxxxx>]

Don,
	Are you talking about re-using the intake gasket?  Years back we
used to reuse the valley-pan (the turkey pan with the metal gasket) over and
over (when we "didn't know any better").  If we had any doubt we put a
little gasket sealer on them, but never had any trouble.

	If you're talking about re-using aluminum intake manifolds, then of
course not.  You should send all used aluminum intake manifolds to me,
especially if they have more than one carburetor flange.  :)

SC

-----Original Message-----
From: Don Gallimore [mailto:dongallimore@xxxxxxx] 
Sent: Tuesday, August 25, 2009 7:01 AM
To: Mailing List
Subject: Reuse B/RB intake Gasket?


I'm wondering if one can reuse the aluminum intake manifold for these
engines?  It was installed last year in the spring and probably has one trip
to Carlisle on it (600 miles) and not much more.

 Akron Don


----
Please address private mail -- mail of interest to only one person --
directly to that person.  I.e., send parts/car transactions and negotiations
as well as other personal messages only to the intended recipient, not to
the Clubhouse public address. This practice will protect your privacy,
reduce the total volume of mail and fine tune the content signal to Mopar
topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.