new electronic distributor problems

[laborboy@xxxxxxxxxxxxx]

Installed the Mopar Performance electronic ignition conversion kit with 
MP high-voltage coil in my 64 Dodge Polara 383 engine. Works fine, but 
when there is a power draw such as lights and/or AC running, the car 
stalls when the car is idling in drive. This is not due to low idle, but 
it seems to be an electrical problem. I know the new coil puts out a lot 
more voltage--is there some adjustment I need to make? The voltage 
regular is the original--would a new one make a difference? Seems like 
it's not sending enough voltage through to feed the ignition system. 

Also, perhaps an unrelated problem. Shortly after install, I had 
problems starting the vehicle--won't turn over, seems like a neutral 
safety switch issue. Any connection, you think?

Zack in Chicago


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.