Re: Balanced flywheel

["Gary H." <spigot2039@xxxxxxxxxxx>]

Thanks for the vendor suggestion. I'll put Tom's on the 62-65 vendor's page. They have some good tech tips too, for example "Slopes VS Angles" on  http://www.4xshaft.com/index.html 

Gary H. 

-----Original Message-----
>From: Wakeman 
>
>
>I few inches away from stock (up-or-down) can do it for sure.  Just ask the 
>lifted 4WD guys.
>
>I highly reccommend Tom Woods Driveshafts for angled leaf spring shims.  All 
>the parts stores carry are crummy, die-cast aluminum shims.  Tom Woods has 
>machined steel shims and he carries a wider variety of angles.  And they 
>aren't that much more money.
>
>Hope you figure it out!
>
>


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.