Re: input shaft diameters

[john althaus <althausjbl@xxxxxxx>]

As I understand it, they both can use the same input bearing, either a 307  
or a 308 depending on the main case, so I would assume the diameter is the 
same.  My question would be "why do you ask" the bearing retainer can be of a 
different  diameter where it fits into the bell housing. There are at least 3 
different  ones that I know of.
 
John  Althaus
64 Savoy Hemi  4spd
Lewisville,  TX 75077
214-673-7540 cell
 
 
In a message dated 2/21/2009 10:43:04 A.M. Central Standard Time,  
neal.zimmerman@xxxxxxxxx writes:

does any  body know if a regular B-body 4 speed has the same diameter
input  shaft  as the hemi B-body 4 speed.  I know the sp lines  are
different , but i am wondering about  the actual shaft  diameter.
neal zimmerman, eugene  oregon


**************You can't always choose whom you love, but you can choose how 
to find them. Start with AOL Personals. 
(http://personals.aol.com/?ncid=emlcntuslove00000002)

[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.