Re: Rocker moulding

[Don Gallimore <dongallimore@xxxxxxx>]

It you are referring to the 4-5" wide rocker panel, I can measure the 
hole spacing tonight if you still need it.  However, I think I'm missing 
a set or two on the front fenders.  There are stains on some of my 
rocker panels that will help fill in the missing spacing.  Let me know.

Akron Don

Mike Phelps wrote:
>  Can someone measure the distance between the front and back of the 
> rocker moulding and the wheel openings on a 65 Belvedere? I'm putting 
> the trim back on and it seems my body man covered up the holes on the 
> quarter and the fender. I'm assuming it's centered between the wheel 
> openings but I'm not sure.  
>
> Thanks
> Mike Phelps
> 1965 Plymouth Belvedere II Convertible
> 361/727
> 2004 Hemi Ram Quad Cab
> 2004 Chrysler 300M 3.5HO
> 2004 PT Cruiser 2.4 Turbo
>
>   


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.