RE: a little help please

[Rich Kinsley <rlkinsley@xxxxxxxxx>]

spigot2039@xxxxxxxxxxx wrote:
> 
> You can get a quote from Dash Specialists in Oregon: 
> http://www.musclecarsonline.com/Dash/index.htm
> 
> Not sure on the arm rest.
> 
> Gary H.
> 
> -----Original Message-----
>  
> >
> >hi all
> >im redoing a 63 polara 500 hard top.going with a 440 bored .030 over 
> >with a 
> max wedge top end.
> >im in need of some information on how i might get the pad redone on the 
> >dash
> as  well as the arm rest ...
> 
====================================================================
Just Dashes in Van Nuys, CA is a good source too. I toured their place a 
couple years ago. I'm not sure about door panels, arm rests , etc but I 
gotta think they probably do some of that too.


Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.