Hi Neal,Make sure your throttle linkage is adjusted properly. If not that will cause the flare in your shift. If that's OK, then you may have a seal going out on the direct clutch in the transmission.
Stevan Miner Miner Auto Service Winnebago, MN -------------------------------------------------- From: "neal zimmerman" <neal.zimmerman@xxxxxxxxx> Sent: Friday, October 10, 2008 7:52 PM To: <1962to1965mopars@xxxxxxxxxx> Subject: tranny hum and surge
concerned about my new 64 cudas 904 torqueflite. it supposedly has a shift kit in it. but the torque convertor is stock. the first thing it does is a gentle hum it makes when u take off, its not a violent or rough sound but i have never heard it in an automatic tranny car before. i beleive it stays there but just gets obliterated by road noise as the speed accelerates. Do shift kits make trannies sound deffierent. Then the second concern is a slight rev between 2and 3 . U can see it rev about 200-300 rpms between shifts on the tach. can that be adjusted out?? thanksneal zimmerman, eugene oregon
---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines:http://www.1962to1965mopar.ornocar.org/mletiq.html.