Re: Adding a SG to a non-SG

[Gary <mopar413@xxxxxxxxxxx>]

You may have to change the pads to under the housing.  Be sure and measure the total lenght of the rear end. To see how close it come to matching up with the one you took out.
---- Don Hudson <mopar4me@xxxxxxxxxxx> wrote: 
> 
> I've got a rear end out of a 69 Dodge A108 that's got 3.91 gears in it.  
> Other than locate a compatible SG unit, just wondering how difficult is 
> it to change it over?  Thanks for any insight on this.
> Don H.
> 
> 
> ----
> Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!
> 
> '62 to '65 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html. 
> 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.