Re: Poly Rocker Shaft Lock

[Gary Pavlovich <glpavlovich@xxxxxxx>]

Bill,

I think I can fix it for you.  Please send me your phone number off-list and 
we can go through it.

Yes, it should have come out easily with vise grips but not to worry.

Gary Pavlovich

----- Original Message ----- 
From: "Bill" <Y1TopBanana73@xxxxxxxxx>
To: <1962to1965mopars@xxxxxxxxxx>
Sent: Tuesday, April 22, 2008 5:39 PM
Subject: Poly Rocker Shaft Lock


> Thanks, but hopefully there's another method out there. Exactly what I
> thought would happen...did. It broke.
>
> Are these things made of pot metal? I was being as careful as I could
> but it didn't take much. I don't see any option but to drill this one
> out now...correct? Any other suggestions? What a f'd up, stupid setup
> from the factory!
>
> What can I do for a replacement? Drill and tap the hole? Some kind of
> roll pin? Help please!
>
> BIll M
> 65 Coronet 500 'vert
>
> On Tue, Apr 22, 2008 at 8:06 PM, Don Dulmage <big-d@xxxxxxxxxxxx> wrote:
> >  Visegrips and wiggle
> >  Don
> >  Author of
> >  Return to Deutschland (True Adventure)
> >  Old Reliable (Mopar)
> >  http://altonapublicschool.faithweb.com/
> >
> >  http://seniordragster.bravehost.com/index.html


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.