Re: Vacuum Fitting Size and Thread Pitch

[Dave Casey <dcasey@xxxxxxxxxxxxx>]

Should be 3/8" NPT.

Dave Casey

----- Original Message ----- 
From: "Dan McCormack" <mcwheels@xxxxxxxxxxxxxx>
To: <1962to1965mopars@xxxxxxxxxx>
Sent: Sunday, April 13, 2008 4:45 PM
Subject: Re: Vacuum Fitting Size and Thread Pitch


> I'm not sure of the exact size you need Dave but I'm pretty sure those are 
> pipe threads.
>
> Dan
>
>
> ----- Original Message ----- 
> From: "David Kincaid" <dave.kincaid@xxxxxxxxxxx>
> To: <1962to1965mopars@xxxxxxxxxx>
> Sent: Sunday, April 13, 2008 4:31 PM
> Subject: Vacuum Fitting Size and Thread Pitch
>
>
>
>
>
> I need to chase the threads on the vacuum port on my manifold and clean up 
> the threads on the fitting/nipple. I don't have a bolt sizer and thread 
> gauge handy, so can someone please tell me the correct size of tap and die 
> I need to purchase to use on these parts? Thanks.
>
> Dave
> '62 300
>
>
> ----
> Please address private mail -- mail of interest to only one person --  
> directly to that person.  I.e., send parts/car transactions and 
> negotiations as well as other personal messages only to the intended 
> recipient, not to the Clubhouse public address. This practice will protect 
> your privacy, reduce the total volume of mail and fine tune the content 
> signal to Mopar topic.  Thanks!
>
> '62 to '65 Mopar Clubhouse Discussion Guidelines:


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.