Re: Underhood security question
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Underhood security question




Rich,

The easiest, least expensive, and most importantly - least invasive is to use a short braided steel line that is plastic coated (to prevent any scratches or abrasion to parts) with the lock loops on each end. Use a small keyed padlock (such as a Master Lock) and you are done. These braided steel lines w/loops can be purchased as a cut-to-fit for your particular application from Home Depot and other such hardware outlets...

Measure your length needs correctly with a piece of rope and have them cut the braided steel to match. Do it right and it will not hang down, be hidden from view, and only you know where to reach with your key to unlock. Been using this method since '68.

Gary Pavlovich
----- Original Message ----- From: "Rich Kinsley" <rlkinsley@xxxxxxxxx>
To: <1962to1965mopars@xxxxxxxxxx>
Sent: Monday, February 18, 2008 12:19 PM
Subject: Underhood security question





Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies

I am wondering if anyone has some suggestions on how to lock our hoods.
It would be very easy to just open the hood and start taking all the
goodies. In the past I put hood pins on my '69 Super Bee and got some
small padlocks to use instead of the pins. That can be an issue if
something is going wrong under the hood and you have it locked. It's not
too easy to open then.

What ideas does the group have?


----
Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.




----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.













Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.