I just replaced both rear wheel cylinders in my 65 Sport Fury Neal, and the backing plates were wet on the outside of both before I started. neal zimmerman wrote: > > yes, except that the rear drum was so stuck i had to pry it off and > when i did the wheel cylinder popped apart and doused everything, so i > couldnt tell. > but even before i began all this , i noticed from under the car > that the backing plate was stained in something , so i couldnt > figure out how a leaking wheel cylinder could necessarily get to the > back side of the backing plate, so I assumed it might be the axle > seal. > anyway , i just took the shotgun approach and fixed all possible > sources. > neal zimmerman, eugene oregon Jeff Adams 64 Polara ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html.