Driveshaft Help!

[don carson <doncarsondodge@xxxxxxxxx>]

Hi Gang;
My '64 Dodge 330 Max Wedge clone is nearing completion
and I need a driveshaft. Originally it was a 318,
pushbutton with the ball and trunion shaft. Now It's a
440 with a '65 pushbutton tranny (using the standard
slip joint yoke) I don't have a yoke to measure for a
driveshaft. Wouldn't a standard 65 driveshaft fit? Can
a few of you measure your driveshaft to give me the
measurement I will need. The procedure is to measure
with the car's weight on all four tires and measure
the length from the front u-joint centerline to the
rear u-joint centerline. 
Or for me it may be best to measure from the 727 case
tail end to the centerline of the rear u-joint. Any
help would be apreciated My rear end is a 742 with a
7290 yoke.
Thanks!
Don Carson


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.