RE: Heater Stuff Again

[Kevin Merkley <krmerkley@xxxxxxxxx>]

Hi,

I went to an industrial gasket/oring supplier and brought the heater 
valve with me.  They gave me the a square oring (for free).  Try a shop 
in your area.

Bring the valve with you so they can see what it is for.  When you tell 
them they will be amazed that you have a car of that vintage and will 
also likely give you the oring.

K.

Bill Maurits wrote:
> 
> I never did get my heater totally squared away this winter. Since I
> can't even get close to 3000 rpm without my heater control valve
> pissing on my foot, I need to find a gasket for it.
> 
> SO...does anyone know of a source for FLAY donut gaskets? I'm looking
> for something that's rubber, ~1/16" thick, and obviously bit enough to
> go around the nub where the heater control valve goes into the heater
> core. Any suggestions? Any places that sell flat sheets of similar
> material that I could make it myself?
> 
> Thanks
> 
> Bill M
> 65 Coronet 500 'vert



Kevin R. Merkley
Thunder Bay, Ontario
64 Dodge 440 2dr HT (Cdn)


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.