I've been trying to make an A990 grille from some spares that I have for my '65 Coronet. After looking at some old photos, it is pretty clear where to make the headlight door and original grill cuts. It is evident that the "added" section of grille goes behind the shortened original grille and the shortened headlight doors. It is also plain that the new section has to be bent a bit in order to fit. My question is how did they originally attach it to the other two sections? It has been suggested that they were only pop-rivetted. Doesn't sound quite right to me though. Does anybody have details on how to do this grille? '65 Coronet 500 stroker ________________________________________________________________________ Check Out the new free AIM(R) Mail -- 2 GB of storage and industry-leading spam and email virus protection. [Non-text portions of this message have been removed] ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html. This email was sent to: arc.6265@xxxxxxxxxxxxxx http:///u/?.. Or send an email to: 1962to1965mopars-unsubscribe@ http:///?p=