Tom, I have about the same luck with any I have purchased over the years. I just gave up and made my own out of thick wall square tubing and casters from Harbor Freight. I made mine so they are universal. The uprights just fit under the oil pan lip and slide back and forth on a cross brace. I have learned over the years to keep a motorcycle tie down strapped across the whole motor just for safety sake. If you find an super ones, please post it. Earl I've just had it with that Summit cradle I have under my 361. A second caster has just broke while I was moving it, it's just a cheap piece of ****. I almost landed it on the crank pulley, thank God I was on the pulley end. I need a good source for a dolley/cradle. I have the stand, the cantilevered kind and don't like it for long term storage. I'm tempted to try and make one. Who out there has what and uses what? Thanks Campers, Tom Duross ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html. This email was sent to: arc.6265@xxxxxxxxxxxxxx http:///u/?.. Or send an email to: 1962to1965mopars-unsubscribe@ http:///?p=