Re: An exhausting situation

[Jim500mopar@xxxxxxxxxxxxx]

In past discussions, there have been favorable reports on different 
aftermarket headers.  I have tti headers on my '65 B-body.  They are expensive, but the 
quality is top-notch, the ceramic coating looks great.  I have been to the 
factory in Corona, Cal., they use state-of-the-art computer controlled 
manufacturing processes that yield very consistent, properly fitting products.  I have 
had them on my 440-based engine for 5 years, no problems.

tti CEO Sam is a great guy, he helped me out after a well-meaning friend's 
bad engine work caused the headers to discolor, they got so hot that the ceramic 
coating was damaged.  I wrote Sam about it, and he recoated them at no 
charge. Plus, he added the internal thermal coating they had not received 
originally, being an early production run set.

There are other brands that cost less and seem to be fine, but you can't go 
wrong if you select the tti's.    

--
[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

. 



http://www/?p=