New to the Mopar world.

[Gary <gary@xxxxxxxxxx>]

For most of my life I have run Fords, with one stint with a Corvette.  I can
work my way around both fairly well.

So now I have 2 1965 Barracudas.
What I need is a good source for Interchange information.

The project car has a 1979 318, and an automatic with a racing slap stick
shifter, no stop brakes, armstrong steering and traction bars.
The intake is from a 340. I just installed a new 600cfm Edlebrock.
The ignition looks like a points and condenser setup.
It has a small differential with 9 bolts.  By rotating the wheel I know it
is not a suregrip. Also by marking the pinion and counting it looks to be
between 3.10 to 3.30 ratio.


I hope to create one road car from the 2. The best is fair. The other is
rust held together with air.  But has good floor pans, and complete set of
chrome, a heater and most of the missing pieces for the project car.

Right now I need to find the driver's side chrome strip that is attached to
the glass and seals against the back seat window.  Anyone have any
interchange ideas?

I have a complete A833 from a 1975 Dart. From peddles to tailstock, bell
housing, pressure plate, disk and throw out assembly.
I will like to add power disk brakes, power steering, a heavier differential
and Air Conditioning.
I would prefer to use Mopar parts, so any ideas for interchange or donor
vehicles would be great.

Thanks

Gary L Matthews


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

. 



http://www/?p=