RE: rear axle swap questions

[mcwheels@xxxxxxxxxxxx]

Neal, there's also a combination u-joint available to adapt a small yoke 
to a large one. Check out this article, it should answer all your 
questions.

Dan

http://www.autohobbydigest.com/8_75.html


Jimmy Peavy wrote:
> 
> I'ts a bolt in. As long as the pinion yoke is a small or large yoke, as 
> the driveshaft.
> 
>    Jimmy
> 
> Robert neal zimmerman wrote:
> 
> >Goal: pull  1964 tapered axle and replace with  1967 8.75 from a '67
> >coronet
> >      Questions:
> >         1) e-brake cable hookup??
> >          2) leaf springs- will the 64 springs bolt up to the 67 rear??
> >            3) driveshaft - different rear u-joint than on 64
> >            driveshaft??  
> >  answer as many as u can stand.
> >  thanks 
> >  neal zimmerman, eugene oregon


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

. 
Or send an email to: 1962to1965mopars-unsubscribe@


http://www/?p=