RE: Valve Cover Resto

[ledman_70@xxxxxxxxxxx]

When I put new wires on my 426 I snipped a quarter inch section off an 
old plug boot, slit one side, and installed them between the wire and 
loom...works pretty good since I couldn't find any grommets.
Jeff
Bill Maurits wrote:
> 
> I'm thinking about pulling my valve covers and possibly intake this
> winter for a clean up & repaint. The wire looms that are on the VC's
> are metal but appear to have had SOMETHING on the area where the plug
> wires snap it. Any ideas whet this was and or what I could use now?
> Maybe some plasti-dip? I just changed the wires and you can see where
> the now bare metal looms were cutting into the wires.
> 
> Thanks
> 
> Bill M
> 65 Coronet 500 'vert



Jeff Adams
64 Polara


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

bSONJP. 
Or send an email to: 1962to1965mopars-unsubscribe@