64 fury Z bar woes

[Bill Jacobs <moperformance@xxxxxxxxxxxxx>]

I've finaly installed the pieces and parts that I have been collecting 
to convert the Fury over to a manual trans.The last parts were the z bar 
and frame brkts and ball.The frame brkt went in the factory holes (3 
bolt)just fine. The trouble is if you put the ball in either one of the 
bellhousing mounting holes the z bar isn't close to being straight.I 
have a brkt with a ball on it and it looks like it would put the z bar 
in the proper position but the 2 holes in it are a lot small then the 
ones on the bellhousing that hold the ball on with.
Is there an adapter that is used to mount the brkt with the ball screw 
to the bell housing? The rod from the clutch peddle lines up great with 
the arm of the z bar,and since it fit in the original holes I think it's 
the right one.
Any help or information is greatly appreciated.
Bill
64 Fury


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

bSONJP. 
Or send an email to: 1962to1965mopars-unsubscribe@