Re: Wanted:64 4 spd. tail housing

[Doug Ahern <D170A833@xxxxxxxxxxxxxxxxxxx>]

On 08 11/19/06, Dodger7998@xxxxxxx wrote:
> 
> 
> Is the tail housing compatiable with the latter model output  shaft with it 
> being a flange type housing on the 64?
>                                                                              

no,, you need to swap the mainshaft (holds gears and is the tailshaft)
there is a 3rd bearing at the end of the tailshaft,  plus the flanged 
adapter.  the main case is the same,   so all you need to do is
swap main shafts and the tailshaft housing.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

bSONJP. 
Or send an email to: 1962to1965mopars-unsubscribe@