I seem to recall hearing of people putting some fiberglass insulation in the column behind the seal to reduce the amount of heat entering the car's interior. Sound correct? Thanks, Gary H. > -------Original Message------- > From: Bill Stevson > Thanks Mike, I didn't think it was going to be easy. > > ---------- Forwarded message --------- > From: MICHAEL > > I recommend pulling the entire column out. You can install the seal > from > the bottom end if you remove the coupling box ( pin thru shaft will > need > to be pressed out). That will let you inspect and lubricate the > coupling. Or you can disassemble the top end to get to the seal. I > usually find the long procedure is best. > > Mike > > On 8/4/2022 9:17 AM, 62-65-mail-list-club-Gary-H wrote: > > Forwarding to the mail list this question from Bill S., as it got > misdirected. > > > > Anyone done this and can provide some help? > > > > Thanks, > > Gary H. > > > > > > > >> -------Original Message------- > >> > >> > >> Greetings from the Ozarks, > >> Can someone give me some guidance here on what needs to be done to > >> install a new seal. > >> Have searched you tube and a couple Mopar sites, have found > several > >> that tell how to rebuild the whole column, but haven't found any > info > >> that specifically addresses this. > >> This is the seal I ordered: > >> > >> Thanks, Bill Stevson > >> '64 Polara 500 convertible, 383 4-speed > >> > > -- -- -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. --- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx. To view this discussion on the web visit https://groups.google.com/d/msgid/1962to1965mopars/20220805203336.7390.qmail%40server309.com.