Re: mixed up main caps

[lxpg1@xxxxxxx]

===========================================================
Your opinion counts! We?re conducting a survey for a 
computer service/repair company. When you complete our 
survey, you will also be entered into a drawing for one of 
ten $100 prizes. Just click
caab6Pib7yoMza/ Val Rad
===========================================================

In a message dated 4/14/2004 9:27:55 AM Eastern Daylight Time, 
threecarb65@xxxxxxx writes:

> The engine does not care about numbers,the engine DOES care that the main 
> bores are all on the same center and the holes are EXACTLY the same size.YES,a 
> line bore is a MUST {if you want the engine to turn over and last}Stan in 
> Montana


   If its a big block and you know that the caps are from that block they 
should be numbered. The sequence  1 through 5 runs from the front of the block to 
the back.  If you know the mains are good (always a gamble) you can 
reinstall, if your not sure get the thing bored. You probably need to have it checked 
anyway for bearing size so why not get it bored. Its a little pricey but worth 
the trouble.

--
[Non-text portions of this message have been removed]

===========================================================
$6.95 .com Domain Name Sale! 
Limited Time! ICANN Accredited GoDaddy! 
caab8Lhb7yoMzf/ GoDaddy
===========================================================

----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 



b7yoMz.