
Also measured the amount of thread above the torsion bar adjuster before removal and put it back as close to the same as possible.
Sent from my iPad
> On Sep 18, 2026, at 10:56 AM, Richard McFarland <firemc1958@xxxxxxxxx> wrote:
>
> Can anyone tell me the ride height on their 63/64 ? Finishing up this front end rebuild. I have the ball joints and lower control arm pivot inside the factory specs as per the service manual. I measured ride height before I started it was 25 1/4” from the concrete to the middle top of the front fender well. Now I’m at 24 1/4”. Counter intuitive to replacing badly worn bushings.Just wondering where y’all’s are set. About to drive the car it should settle a bit. Wanting to see how far off I am.
> Thank you
> Richard
> Sent from my iPad
--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/4D1FC828-89A7-4B74-BB0E-14A31173CCFD%40yahoo.com.