Re: {Chrysler 300} Vacuum on my 300 F

["'dave mason' via Chrysler 300 Club International" <chrysler-300-club-international@xxxxxxxxxxxxxxxx>]

I think someone mentioned this already but if you did the carb setup according to the FSM as Nick mentions, double check the choke settings.  

Idle the car without the air cleaners, and make sure the chokes are opening more or less the same.  If they are too far open note that too.  You can cover a carb with your hand to restrict air flow and if it runs better the choke is too open.  Usually they don’t open enough if anything.  

D&K

Sent from my iPhone

On Sep 9, 2025, at 22:13, Nick Taylor <nicksgaragesd@xxxxxxxxx> wrote:



1. What is the history of the engine? 

2. Is the throttle linkage adjusted using the factory procedure?

3. Eliminate all vacuum leaks, windshield washer harness, heater control, etc.

4. Carbs properly synched up for air flow? Use a Uni-Syn for this.

On Tue, Sep 9, 2025 at 6:18 PM 'Jay Williamson' via Chrysler 300 Club International <chrysler-300-club-international@xxxxxxxxxxxxxxxx> wrote:

Hello,

I’ve been working to make my 300 F run as bad as I possibly can and I think Ives succeeded. The car has never really had a smooth idle, so I replaced the plugs, cap, condenser, plug wires and points. Re-gapped the points to .017 and the plugs to.035. When I check the volume at idle with the car properly timed, I’m pulling 10psi off the passenger side vacuum port. That seems a bit low to me. Brake booster is holding vacuum and I have replaced all vacuum hoses. I’m running out of ideas.
Jay Williamson
Sent from my iPad

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/206BF324-123D-4597-9DB7-F1D7210B2103%40icloud.com.

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/CA%2BjApFMhyUqLDty8RDS_GFX0kK9gT1YDWrBLDyjXgdeuN4574g%40mail.gmail.com.

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/E1C9772E-81FF-4F93-9E0F-9DD72FF14831%40yahoo.com.