{Chrysler 300} Gasket maker. Yes or no?

["'Jay Williamson' via Chrysler 300 Club International" <chrysler-300-club-international@xxxxxxxxxxxxxxxx>]

There has been a debate for a long time regarding the use of gasket maker on valve cover gaskets. I’m about to take on the task of changing my valve cover gaskets on my 300F. They are cork gaskets and typically I would not use gasket maker. However, this is a big job and I only want to do it once. I’m thinking of using spray on copper gasket maker on the valve cover side only. What are the thoughts out there?

Jay Williamson
Sent from my iPad

-- 
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
--- 
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/922F9929-2E69-472D-B274-B8617443F041%40icloud.com.