|
I just placed an order for the Vintage Air servo heater control valve. I really want to get the valve out of the cockpit. Over the decades I have head them start to leak and stain
carpet. In addition, on the 300K it is a real PITA to get too. Removing the glove box and a wiper link and the cable catching on things to get it off… My plan is to make a bracket to screw into the same holes as the existing and then mount the unit on it on the engine side. Since they make a linear potentiometer for use with a
cable, I can make a little bracket and place inside the dash down low and accessible and then just run the wire out to the valve. I may also look at making a bracket with a short rid with some spherical joints to push pull on the POT right at the back of the controller and do away with the cable entirely. When I am done, I will post some photos of how it all works or not. I mean for a $160 and a couple of hours of work to get that thing out and more accessible, if it works it will
be a good thing for a daily driver. James For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang --- You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group. To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx. To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/CY5PR19MB61719D8A430B84694EFA41A5939C2%40CY5PR19MB6171.namprd19.prod.outlook.com. |
Back to the Home of the Forward Look Network
Archive Sitemap