{Chrysler 300} 300K throttle bracket bushing PITA

["'James Douglas' via Chrysler 300 Club International" <chrysler-300-club-international@xxxxxxxxxxxxxxxx>]

Some time back someone asked me what I did with that busing that likes to fall out of the firewall side of the throttle bracket.  I am pulling all my old phone photos off and I ran across what I did. Posting them here for anyone who may want to see it.

 

I used some plastic to metal epoxy I got at the local hardware store. Even the same color as the loose fitting, as seen in the one photo, plastic bushing. I just used a tapered drift to expand that bushing out and then let the epoxy dry. I scrapped to get the paper towel off when it was done.

 

If that bushing falls out and it DOES you are stuck. This way that will never happen. If you ever need to change it you can just take a torch and burn the epoxy and old bushing off and clean it and do it again.

 

James

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/CY5PR19MB6171F3796EB2829DDDA35B0593EB2%40CY5PR19MB6171.namprd19.prod.outlook.com.

Attachment: IMG_5944.JPG
Description: IMG_5944.JPG

Attachment: IMG_5943.JPG
Description: IMG_5943.JPG