James, I’ve used Eastwood’s Silver Cad replication coating spray #100222 with very good results. Good up to 300 degrees so can be used on under hood components. Bob J From: 'James Douglas' via Chrysler 300 Club International <chrysler-300-club-international@xxxxxxxxxxxxxxxx> Probably silver cadmium. Perhaps Silver Zinc. In any event, if doing a concourse job, you can get it plated. Cad is the most expensive and the most toxic. Silver zinc is priced ok, but it tends to turn or fade in a couple of years. Some have done a dull nickel plate that holds up well over time. I know several who used it on E-Type suspensions and did it at home. For non-concourse cars I use Eastwood Tank tone paint. It holds up fairly well and goes on without any primer. I use it for brackets and factory nuts and bolts. At about the 10 year point it may need to be repainted if the car is driven a lot. James From: 'Matt Allyn' via Chrysler 300 Club International <chrysler-300-club-international@xxxxxxxxxxxxxxxx> Hello, All of the parts & pieces that make up the Throttle Linkage to Trans. Kickdown Linkage….. How did the cars leave the factory? Were the parts Cad Plated? I can’t imagine they were bare metal (as they would have rusted; right?) Here is a piece that is bare metal; but wondering what it is supposed to be…? Thanks! Matt Allyn -- -- For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang --- You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group. To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx. To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/007d01da2091%24ca4b7320%245ee25960%24%40comcast.net. |