Re: {Chrysler 300} Problem

Hi Bill;

How about cutting the pipe and sweating in a copper coupler fitting to orient the end as needed?

Not as new, but it seems like many have made do with rubber hose all the way across the valley.

At least you'll be close to as designed, and not really very noticeable.

Ray

On Sun, Jul 9, 2023 at 1:56 PM william ELDER <belder@xxxxxxxxx> wrote:

Thanks to everyone who responded to my copper heater pipe question. I have to believe at this point that the driver side pipe is not bent correctly. I finished up my distributor restoration today and dropped it into position. I wanted to make sure that I would be able to hook up the pipes to the front water pump housing nipples. I have decided to buy some Gates hoses that have a molded 90 degree elbow. I should be able to make the hose connections without collapsing the hoses.

Thanks Again
bill

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/007b01d9b28e%249e2734d0%24da759e70%24%40cogeco.ca.