Re: {Chrysler 300} Rear Window Clips 300K

[Michael Van der veen <michaelvanderveen8@xxxxxxxxx>]

Hi James, 

The clips are available. I believe we used a kit that suited b body dodge plymouth. The clips are the same. Eyeball one and make sure it's the same but they are a fairly generic clip. Look at this link below.

https://www.classicindustries.com/product/mb1169.html

Cheers

Mike in cold Australia 

On Sun, Jul 2, 2023, 4:00 AM 'James Douglas' via Chrysler 300 Club International <chrysler-300-club-international@xxxxxxxxxxxxxxxx> wrote:

Hi All,

 

In previous 300K’s we were doing full body paint inside and out. On this car I am not.

 

I pulled the rear window molding and when everything was cleaned I had a very good new and sort of bad news thing.

 

The two lower corners where I have almost always seen rust issues looks very good. A little surface scale and that is about it. Although one cannot see it in the photos with an intense light and looking down past the seal the metal looks better the deep one looks.

 

The problem is the lower molding clips are shot. The tops have rusted away. I REALLY do not want to take the rear window out. The window looks good and seals.

 

My question to the group is does anyone have any creative solutions to this issue? I typically fill the space between the window rubber and the body with 3M rope mastic and then push the molding in. Perhaps this will hold it. It stays pliable for a very long time.

 

Thoughts? The car goes into the shop for a street paint job this Friday.

 

James

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/CY5PR19MB6171D19CEBDB74AA0FDB27D1932BA%40CY5PR19MB6171.namprd19.prod.outlook.com.

-- 
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
--- 
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/CAPtwmMFVK%3D5ZkVV8coo%2BSEo%3D2KRajbie9-u0MA_t0zsiZE226w%40mail.gmail.com.