{Chrysler 300} 62 300 parts

Hello all, I am looking for a few things before Fall Hershey for my Uncle Howards 62 300 Sort.

The car has dual inline 4 barrels almost done properly like the H. I did get the correct coil bracket and return spring brackets from Neil at Dynamic Restorations but was wondering if anyone has any suggestion on paint for these brackets. I feel like it will be impossible to make them look right against the 60 year old engine paint. From my research they should match the block color.

I would like to find two air filter lids that are gold. The ones on this car are chrome which I learned is not correct.

I am looking for an H passenger side exhaust manifold with the fitting for the heat tube to the carburetor. I have all of that set up but it is kind of rigged up into the sport 413 manifold for a single 4 barrel.

I am planning to call the guys who took over Gary Goers inventory tomorrow for a trunk mat. I have never found any good trunk mats for these era mopars so any input would be appreciated on this.

Last two things I am looking for is a source for the spring type heater hose and radiator hose clamps, and proper intake manifold bolts. These seem to be miss matched somehow.

Oh last thing, this car seems to have seat belt mounts in the rear floor but I have yet to come across the belts or buckles. If anyone has anything, or any idea what I should even have I would appreciate that also. Or maybe those eyelets would be there regardless of if seatbelts were installed. Thanks again for any info.

Drew Carl
Owner, eScore

Phone: 724-288-6636

Email: drew@xxxxxxxxxxxx

Website: www.escoremx.com

Address: 1280 Henderson Avenue Washington, PA 15301