I believe by 1970 they Changed to a solid adjustable Bracket. You could upgrade To that. Those floating Brackets were bad news wore Out fast. Bob Haag On Mar 30, 2022, at 12:19 PM, John Grady <jkg@xxxxxxxxxxxxxxxxx> wrote:
This is factually a really bad design , bad idea they dropped soon after , —original idea was pull of belt self tensions it = no adjustment needed at factory . But it constantly bounces around with tension changes in belt or change in speed of engine . Then , the hole in steel bracket at hinge wears egg shaped at the front , this tilts the axle of pump down , you can plainly see the plane of the pulley is wrong ( put flat edge on pulley , pulley is tilted ) belt runs in at angle , can slip , but wears crazy on one side etc ( can’t have tilted pulleys on a V belt ) To attempt to stop the bouncing they put a rubber wedge in there , it get soft often gone . Whole idea is no good.
First thing I fixed on the first F I got about 1969 , essence of fix was to drill all the holes oversize in line and straight , a close fit for a long shoulder bolt acted like a controlled OD pin , then put a pipe spacer between tabs so you could clamp it solid like god wants a ps pump mounted . And what the rest of world did before and since , tighten the belt and tighten clamp . Done . No more bouncing motion there That May have been overkill ,—- just go up to larger long bolt and the pipe spacer . Like alternator is mounted , or two oversize bolts with nuts that are a good fit . You can also add a small bolt across the gap in the two piece mount by drill and tap to act as an adjuster— to be sure it can’t loosen up —-but a tight big bolt is ok too.
I Once made a little kit for this , some original members may remember it … Also made SS springs for generator brushes back then , the other aggravating problem on these cars ,the plain steel brush spring rusts , brush sticks in the holder . Instead of new generator and a dance with generator experts and 500$ , just tap back end of generator with dead blow hammer . Instant charge again . Or reach in abs move from back with screwdriver Then one day take off, clean brush holders and put in good springs . I had 100 stainless springs made can’t find the box , 50 years ago .. good repro project , both of these issues .. john Sent from my iPhone On Mar 30, 2022, at 11:47 AM, RICK AND DEBBIE CLAPHAM <rixpac@xxxxxxx> wrote:
--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/579AE7B3-47BE-4FB8-B2FA-8366A57E7120%40gradyresearch.com.
--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/0414DC76-A067-44FA-89EA-EE10C687D016%40cox.net.
|