Re: {Chrysler 300} Power Steering Pump Cap

[Marshall Larson <granitledge@xxxxxxxxx>]

My caps are not marked as vented but they in fact are. Look at the center of the gasket inside the cap for a small + sign. It penetrates the gasket and is located below a raised area in the outside center of the cap. That area is tall enough to have fractured the metal to create a tiny hole at each end to allow venting. 

On Thu, Nov 18, 2021 at 12:11 PM Ron Kurtz <mark6268@xxxxxxxxxxxxx> wrote:

Hello, everyone:

The service manual and parts catalog do not specify whether or not the cap is vented. I have a cap that is not stamped "vented." Is it okay to use on a '64 pump?

Best,

Ron Kurtz

E #292 

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/190760490.1873151.1637259099643%40mail.yahoo.com.

--

Marshall Larson

-- 
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
--- 
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/CACuDFNTcLRADwrDVXT_uwr7xe_rDXxSCxnvdVJjnk%2B1-d4B%3DBQ%40mail.gmail.com.