{Chrysler 300} Steering shaft installation

[RICHARD HUSS <rhuss214192@xxxxxxxxxxx>]

1961 300G 

I had the steering box rebuilt by Steer and Gear When I removed the shaft two pcs of copper came out with the rubber bushing. now I do not know how to reinstall them or why. the larger one is 1/2” wide and 1 1/2 long with a fold at one end that I assume stays outside the rubber bushing. There are also two pcs of plastic that go inside the bushing and can either isolate the copper from the shaft or fit between the copper strips and the rubber bushings. 

Any help on how to install?  note the small pcs of copper is curved as if it fits on the exterior of the rubber bushing. 

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/53B41987-AC49-40BB-B18C-2CE21FF02E08%40comcast.net.