Re: {Chrysler 300} 1962 300 - Auto Choke

[Marshall Larson <granitledge@xxxxxxxxx>]

Perhaps it needs some lubricant on it's pivot points or there is some slight mechanical interference. When removed from the manifold you will see it has a graduated scale to be used for adjustment.

On Sun, Sep 26, 2021 at 8:28 PM 'Matt Allyn' via Chrysler 300 Club International <chrysler-300-club-international@xxxxxxxxxxxxxxxx> wrote:

On my 1962 300 Sport…with a 383 & a 4-barrel….
I have the Automatic Choke - Well Type; that lives in the intake manifold.

Once the motor is fully warmed up, the choke plate does not open fully; unless I flick it fully open with my hand.
Not sure if the well choke needs adjusting?
Or if its rod to the carburetor choke plate needs to be bent?

Seeking any thoughts & ideas.
I see the Service Manual reflects notches on the choke; I guess I can pull it out & see where that notch is aligned to.

Thanks!
Matt Allyn

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/96007F12-A748-4D0A-8947-27B76D348EFC%40yahoo.com.

--

Marshall Larson

-- 
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
--- 
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/CACuDFNRv%2BgV3b6bQbB8z%3DxfwqFtRHcmDYK7_%2BXLr5f9pE0Kcrg%40mail.gmail.com.