{Chrysler 300} '64 Torqueflite Throttle Linkage Adjustment
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

{Chrysler 300} '64 Torqueflite Throttle Linkage Adjustment



Hello, everyone:

Following the manual diagram (page 21-49) to adjust the trans linkage for the correct pedal height, everything is fine until I attach pedal rod to the accelerator shaft bracket. The pedal drops way below 113-115 deg. (after removing the 3/16" rod) and will press down only about an inch. I tried several times reassembling the linkage with the same result.  

Any suggestions?

Best,
Ron Kurtz
E #292

-- 
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
--- 
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/1756818673.924732.1627249310293%40mail.yahoo.com.


Home Back to the Home of the Forward Look Network Archive Sitemap


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.