Re: {Chrysler 300} Cam grind!

[Rob Kern <robkern@xxxxxxxxxxxxx>]

Michael,

Clay Smith Cans in California.  I purchased one on advice from John Lazenby for my C a few years ago just to have a spare on hand, as I figured this to be a dead in the water part failure item.  Used in the engine rebuild last summer when I spun 2 connecting rod bearings in my 392.  Much better performance, especially high end.  Very close to factory spec cam grind for the 375 HP 392 of 1957. Hope this helps!  300’ly, Rob Kern

On Jun 11, 2021, at 10:21 AM, micke.sundbom <micke.sundbom@xxxxxxxxx> wrote:

 Hello

  Is there any i  this group had a new 55,56,57 300 camshaft manufactured.  Maybe someone used Schnider, Howards, Chris Neilson, Chet Herbert or any other cam specialist.  Any info of your cam grinder is welcome.

 Heads done all new std specs,  cam out! 

Regrind is not on the agenda.

Thanks Michael

Skickat från min Galaxy

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/60c37f7f.1c69fb81.87249.3a59%40mx.google.com.
<20210608_143811_resized.jpg>

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/1496CEEE-ECE2-4834-8A3F-AD1192BE1CCF%40sbcglobal.net.