Use whatever it takes, no one is going to care and/or see them unless they tear out the inner rear trunk panels.
Best of the New Year to everyone on board here from Dave & Carolyn Schwandt
From: chrysler-300-club-international@xxxxxxxxxxxxxxxx <chrysler-300-club-international@xxxxxxxxxxxxxxxx> On Behalf Of Dieter Isler 8496
Sent: Friday, January 1, 2021 1:27 AM
To: Nick Taylor <nicksgaragesd@xxxxxxxxx>; , Chrysler 300 Club International <chrysler-300-club-international@xxxxxxxxxxxxxxxx>
Subject: Re: {Chrysler 300} 300F Rear panel trim clips
Happy New Year!
My 300F under restoration had screw type clips all around. Some were rusted metal screw clips (passenger side stainless molding from the license plate pocket) and most of the passenger side stainless steel molding clips were plastic clips with screw. All screws were sealed with a rubber ring between the screw and the sheet metal. Driver side stainless steel molding and stainless steel molding to the license plate pocket were apparently never ever mounted again after an accident at the drivers side rear corner.
Kind regards
Dieter
On 31.12.2020 22:18, Nick Taylor wrote:
I had the rear bumper redone for my F and before I install it, I'm replacing the chrome around the license plate pocket and the two stainless moldings on either side of it. I got an NOS one for one side and it came with new clips. Three squeeze clips and one screw on one. Looking at my car, it has nuts holding on the original molding. Which way is correct?
Doesn't really matter to me but a friend is restoring his F where he's missing most of the clips and screws for everything on it.
--
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/8d9ca2d8-0cf1-4865-9b56-b3e009f425d4n%40googlegroups.com.
--
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/25e443b1-f90a-df01-1acf-c6c8faa1125f%40bluemail.ch.
