David, Welcome to the club. If you haven't already, visit the website information on seat belt installation: http://www.chrysler300club.com/tech/fseatbelt/fseatbelt.html The instructions there are scans taken from eBay sales and may be hard to read, but they are the best we have right now until someone comes forward with better original scans. Figure 5 shows installation for a '60-'61 front 300. Also: http://www.chrysler300club.com/tech/sbelts/1.html Figure 1 shows backseat installation from MoPar kit. I do not have rear seat belts installed in my G, so I can't offer guidance for the rears, but the instructions indicate there are dimples in the metal that mark where to drill. My front belts are vintage aftermarket and the anchor bolts are backed under the car with large fender washers, I would think you would get these as part of the kit you buy. Take your time and be careful where you drill to avoid damaging fuel or brake lines. You'll need to pull the rear seats to determine mounting points, so allow plenty of time to get it right. Bob J From: Chrysler300@xxxxxxxxxxxxxxx [mailto:Chrysler300@xxxxxxxxxxxxxxx] On Behalf Of dgalba@xxxxxxxxx [Chrysler300] Hi Chrysler 300 Members, I am installing seat belts in my 300G in all 4 seats for my young kids and the parents, too. Does my 300G have "eye-bolts" in the floor board to anchor the seat belts? Or, does the 300G have dimples in the floor where I would use a Bolt Down Anchor kit with end fitting to anchor the belt? And, finally, would 74" inches work for the front and 60" in the back? Thank you for your reply. David __._,_.___ Posted by: "Bob Jasinski" <rpjasin@xxxxxxxxxxx> To send a message to this group, send an email to: Chrysler300@xxxxxxxxxxxxxxx To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or go to https://groups.yahoo.com/neo/groups/all/manage/edit For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang __,_._,___ |