Hi, in the middle of a special project, had those new snazzy SS headers for 392, they land right on top of torsion bar. So much for plan A . Plan B is the 4 bolt truck or hi po 392 manifold . I bought two of these a few years back,…used them in a 300 restoration, someone was making them, but generally sold out ..old also works. Used on Dodge 392 trucks and supposedly 390 HP 392 . Early ones are rounded, probably never intended for cars, but then some were made with a flat on one outer side to better clear drivers side control arm mounts , on cars, even then engine was shifted to pass side about ½” ; got into all that. So looks like into it again . Very difficult to bend a 2.5” exhaust even on those, to clear torsion bar ..by ½” maybe an aaaugh..again. I have some hope that a pair are sitting in your garage , in the way , this Sunday afternoon.. Hope??? Let me know, --and thank you, John __._,_.___ Posted by: "John Grady" <jkg@xxxxxxxxxxxxxxxxx> To send a message to this group, send an email to: Chrysler300@xxxxxxxxxxxxxxx To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or go to https://groups.yahoo.com/neo/groups/all/manage/edit For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang __,_._,___ |