Re: [Chrysler300] RE: 300 G heater hoses
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Chrysler300] RE: 300 G heater hoses





​My second to last S/N G has copper heater lines.  They connect to the pump with very short hose, pass under the manifolds to the rear of the engine and connect to the heater with hose.  There are individual clamps on rear valley cover bolts to restrain them there but hoses at the pump are so short that they can't move.  They are formed rigid copper so they make a smooth transition from front to rear.
 
I polished them and shot them with clear when I rebuilt the engine.  Likely not original but they look nice.

On Mon, Dec 21, 2015 at 12:31 PM, 'Bob Jasinski' rpjasin@xxxxxxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:
 

John et al,

 

The 300G heater hose routing has been something I have not been able to pin down as correct as long as I've had my G, and that is many years.  I have period photo's of 300G engine compartments that show the hoses installed above the intakes, no copper, just hoses, in two configurations, one going around the air cleaner and one through the middle, in addition, I have another photo that shows them underneath the intakes.  Hard to tell though, if there is copper there, I suspect there is.

 

Happy Holidays!!!

 

Bob J

 

From: Chrysler300@xxxxxxxxxxxxxxx [mailto:Chrysler300@xxxxxxxxxxxxxxx] On Behalf Of 'John Grady' jkg@xxxxxxxxxxxxxxxxx [Chrysler300]
Sent: Monday, December 21, 2015 10:00 AM
To: 'Robert Augliera'; 'David Schwandt'; 'Jerry Lindsay'; 'chrysler300@xxxxxxxxxxxxxxx Club'
Subject: RE: [Chrysler300] RE: 300 G

 

 

AHA!!! Brings up the copper lines. Were they on all F/G cars? I have had a
few for sure untouched F with them, I see many at club meets without them. I
have a few without them, but replacement hoses. All original hoses are
pretty much gone now? Anyway? I think replaced in early days. At least some
had copper taken off, hose run end to end. Just a service job in 60's. Hot
topic w George, in the way back. And whether under the rams w one hose, if
hoses were stock. The clip on some cars says two hoses. . Maybe settled
long ago, but still up in air for me..

-----Original Message-----
From: Chrysler300@xxxxxxxxxxxxxxx [mailto:Chrysler300@xxxxxxxxxxxxxxx] On
Behalf Of Robert Augliera raugliera@xxxxxxxxxxxx [Chrysler300]
Sent: Monday, December 21, 2015 12:37 PM
To: David Schwandt; 'Jerry Lindsay'; 'chrysler300@xxxxxxxxxxxxxxx Club'
Subject: RE: [Chrysler300] RE: 300 G

There is a few pre-bent hoses off water pump housing. Not sure if 5/8 hose
will make that tight bend into copper lines

From: David Schwandt [mailto:finsruskw@xxxxxxxxxxxxxxx]
Sent: Monday, December 21, 2015 11:24 AM
To: 'Jerry Lindsay' <jerrylindsay300h@xxxxxxxxxxxxxxx>; Robert Augliera
<raugliera@xxxxxxxxxxxx>; 'chrysler300@xxxxxxxxxxxxxxx Club'
<Chrysler300@xxxxxxxxxxxxxxx>
Subject: RE: [Chrysler300] RE: 300 G

Good point, Jerry
I recall than now as well.
Might be worth looking into.
Maybe the club or a member could get a decent price break on a bulk order
and make it available to the members.
I'd be in for at least 3 cars worth

Dave Schwandt

From: Chrysler300@xxxxxxxxxxxxxxx<mailto:Chrysler300@xxxxxxxxxxxxxxx>
[mailto:Chrysler300@xxxxxxxxxxxxxxx] On Behalf Of 'Jerry Lindsay'
jerrylindsay300h@xxxxxxxxxxxxxxx<mailto:jerrylindsay300h@xxxxxxxxxxxxxxx>
[Chrysler300]
Sent: Monday, December 21, 2015 10:21 AM
To: 'David Schwandt'; 'Robert Augliera'; 'chrysler300@xxxxxxxxxxxxxxx Club'
Subject: RE: [Chrysler300] RE: 300 G

I believe I was told one time that my "H"'s ribbed heated hoses are the same
as those used on a corvette, which I believe are still available. Perhaps
one of our club members with better knowledge of this subject can better
answer it.

Jerry Lindsay

From: Chrysler300@xxxxxxxxxxxxxxx<mailto:Chrysler300@xxxxxxxxxxxxxxx>
[mailto:Chrysler300@xxxxxxxxxxxxxxx] On Behalf Of 'David Schwandt'
finsruskw@xxxxxxxxxxxxxxx<mailto:finsruskw@xxxxxxxxxxxxxxx> [Chrysler300]
Sent: Monday, December 21, 2015 10:59 AM
To: 'Robert Augliera';
chrysler300@xxxxxxxxxxxxxxx<mailto:chrysler300@xxxxxxxxxxxxxxx> Club
Subject: RE: [Chrysler300] RE: 300 G

Kit???

It's 5/8" standard heater hose.

I doubt if you can find the older ribbed style

Just make sure it's black and you'll be fine.

Unless you Club concourse the car, no one will know the difference

Goers has the correct corbin style clamps in a 'kit'

And pick up the correct style batt hold down and use a black battery and
your engine compartment will look about as stock as it can get.

Good Luck!!

From: Chrysler300@xxxxxxxxxxxxxxx<mailto:Chrysler300@xxxxxxxxxxxxxxx>
[mailto:Chrysler300@xxxxxxxxxxxxxxx]<mailto:[mailto:Chrysler300@yahoogroups.
com]
> On Behalf Of Robert Augliera
raugliera@xxxxxxxxxxxx<mailto:raugliera@xxxxxxxxxxxx> [Chrysler300]
Sent: Monday, December 21, 2015 9:36 AM
To: chrysler300@xxxxxxxxxxxxxxx<mailto:chrysler300@xxxxxxxxxxxxxxx>
Subject: [Chrysler300] RE: 300 G

Cummins red it is.

Is there a heater hose kit available

Thank you

Rob

From: Robert Augliera
Sent: Monday, December 21, 2015 10:03 AM
To: 'chrysler300@xxxxxxxxxxxxxxx'
<chrysler300@xxxxxxxxxxxxxxx<mailto:chrysler300@xxxxxxxxxxxxxxx>>
Subject: 300 G

Any suggestions for the color red used on intakes.

Rob

[Non-text portions of this message have been removed]

[Non-text portions of this message have been removed]

------------------------------------
Posted by: Robert Augliera <raugliera@xxxxxxxxxxxx>
------------------------------------

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or go to
https://groups.yahoo.com/neo/groups/all/manage/edit

For list server instructions, go to
http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to
http://www.forwardlook.net/300-archive/search.htm#querylang
------------------------------------

Yahoo Groups Links




--
Marshall Larson


__._,_.___

Posted by: Marshall Larson <granitledge@xxxxxxxxx>


To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to https://groups.yahoo.com/neo/groups/all/manage/edit

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang




Visit Your Group
Yahoo! Groups
PrivacyUnsubscribeTerms of Use

__,_._,___


Home Back to the Home of the Forward Look Network Archive Sitemap


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.