There is a few pre-bent hoses off water pump housing. Not sure if 5/8 hose will make that tight bend into copper lines
From: David Schwandt [mailto:finsruskw@xxxxxxxxxxxxxxx]
Sent: Monday, December 21, 2015 11:24 AM
To: 'Jerry Lindsay' <jerrylindsay300h@xxxxxxxxxxxxxxx>; Robert Augliera <raugliera@xxxxxxxxxxxx>; 'chrysler300@xxxxxxxxxxxxxxx Club' <Chrysler300@xxxxxxxxxxxxxxx>
Subject: RE: [Chrysler300] RE: 300 G
Good point, Jerry
I recall than now as well.
Might be worth looking into.
Maybe the club or a member could get a decent price break on a bulk order and make it available to the members.
I'd be in for at least 3 cars worth
Dave Schwandt
From: Chrysler300@xxxxxxxxxxxxxxx<mailto:Chrysler300@xxxxxxxxxxxxxxx> [mailto:Chrysler300@xxxxxxxxxxxxxxx] On Behalf Of 'Jerry Lindsay' jerrylindsay300h@xxxxxxxxxxxxxxx<mailto:jerrylindsay300h@xxxxxxxxxxxxxxx> [Chrysler300]
Sent: Monday, December 21, 2015 10:21 AM
To: 'David Schwandt'; 'Robert Augliera'; 'chrysler300@xxxxxxxxxxxxxxx Club'
Subject: RE: [Chrysler300] RE: 300 G
I believe I was told one time that my "H"'s ribbed heated hoses are the same as those used on a corvette, which I believe are still available. Perhaps one of our club members with better knowledge of this subject can better answer it.
Jerry Lindsay
From: Chrysler300@xxxxxxxxxxxxxxx<mailto:Chrysler300@xxxxxxxxxxxxxxx> [mailto:Chrysler300@xxxxxxxxxxxxxxx] On Behalf Of 'David Schwandt' finsruskw@xxxxxxxxxxxxxxx<mailto:finsruskw@xxxxxxxxxxxxxxx> [Chrysler300]
Sent: Monday, December 21, 2015 10:59 AM
To: 'Robert Augliera'; chrysler300@xxxxxxxxxxxxxxx<mailto:chrysler300@xxxxxxxxxxxxxxx> Club
Subject: RE: [Chrysler300] RE: 300 G
Kit???
It's 5/8" standard heater hose.
I doubt if you can find the older ribbed style
Just make sure it's black and you'll be fine.
Unless you Club concourse the car, no one will know the difference
Goers has the correct corbin style clamps in a 'kit'
And pick up the correct style batt hold down and use a black battery and
your engine compartment will look about as stock as it can get.
Good Luck!!
From: Chrysler300@xxxxxxxxxxxxxxx<mailto:Chrysler300@xxxxxxxxxxxxxxx> [mailto:Chrysler300@xxxxxxxxxxxxxxx]<mailto:[mailto:Chrysler300@xxxxxxxxxxxxxxx]> On
Behalf Of Robert Augliera raugliera@xxxxxxxxxxxx<mailto:raugliera@xxxxxxxxxxxx> [Chrysler300]
Sent: Monday, December 21, 2015 9:36 AM
To: chrysler300@xxxxxxxxxxxxxxx<mailto:chrysler300@xxxxxxxxxxxxxxx>
Subject: [Chrysler300] RE: 300 G
Cummins red it is.
Is there a heater hose kit available
Thank you
Rob
From: Robert Augliera
Sent: Monday, December 21, 2015 10:03 AM
To: 'chrysler300@xxxxxxxxxxxxxxx' <chrysler300@xxxxxxxxxxxxxxx<mailto:chrysler300@xxxxxxxxxxxxxxx>>
Subject: 300 G
Any suggestions for the color red used on intakes.
Rob
[Non-text portions of this message have been removed]
[Non-text portions of this message have been removed]