Richard, If stainless is not mandatory, Go to any parts store and buy a 32" steel line. Make 2 dog leg bends about 3 1/2"-4" on both ends. Take your drivers side carb just far enough off the 4 pins and drop in the line on both ends and set the carb back on the 4 pins. tighten up both ends before you re-tighten the 4 carb nuts. It fits straight as an arrow on top of the balance tube and under the bell crank. If you tighten right, it won't touch the rams either. Jerry --- Richard Osborne <richard@xxxxxxxxxxxx> wrote: > Good morning, > > While driving the G back from Carlisle, I began to > notice an odor of gasoline. This was after driving > perhaps 150 miles. Due to tire problems which Tom > Miiller was having with his C, we pulled over to > check out his car on the turnpike. When finished, I > popped the hood on the G to find a rather serious > stream of gasoline running from the fuel line going > into the left side carb. It was coming from the > line, not the brass fitting into the carb. > > This seems odd to me as I drive it a lot around > town. I drove it 350 miles plus to Carlisle and > didn't notice anything. Anyways, the fitting on the > line was too rounded to use the open end of the > wrench. I took the line off and slid the box end > over the line and was able to get it tight enough > where it stopped dripping, was only damp. > > The line is stainless, I am going to have that line > re-made. I assume it no longer seats due to the > number of times it has been off. Why didn't it leak > when I first started the car? Why could I not get it > tight enough to stop entirely? Could the brass > fitting be damaged? > > Best regards, > > Richard Osborne > > > > ------------------------ Yahoo! Groups Sponsor > --------------------~--> > Yahoo! Groups gets a make over. See the new email > design. > http://us.click.yahoo.com/WktRrD/lOaOAA/yQLSAA/8LmulB/TM > --------------------------------------------------------------------~-> > > > To send a message to this group, send an email to: > Chrysler300@xxxxxxxxxxxxxxx > > For list server instructions, go to > http://www.chrysler300club.com/yahoolist/inst.htm > > For archives go to > http://www.forwardlook.net/300-archive/ > Yahoo! Groups Links > > > Chrysler300-unsubscribe@xxxxxxxxxxxxxxx > > > > > > To send a message to this group, send an email to: Chrysler300@xxxxxxxxxxxxxxx For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm For archives go to http://www.forwardlook.net/300-archive/ Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Chrysler300/ <*> To unsubscribe from this group, send an email to: Chrysler300-unsubscribe@xxxxxxxxxxxxxxx <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/