Fwd: Re: [Chrysler300] Torqueflite trans

[JAMES PRISTELSKI <ajp0002@xxxxxxxxxxxxx>]

Further info on replacing the torque converter ring gear: 
   
  The manual tranny in 1961 has a different diameter ring gear on the flywheel.  Since not many manual trannys were sold, it is fairly common.  Make sure that you get the correct one.  
   
  Also, the ring gear is a tight fit on the torque converter.  As described in the 1960 shop manual, you will probably have to heat the ring gear with a torch to slightly expand its diameter to get the old one off.  As I recall, it recommends preheating the new one in an oven, rather than with a torch, to expand it for installation.  However, I would bet that my welding friend used his torch for that as well.  
   
  

 forwarded message attached.


[Non-text portions of this message have been removed]



To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Chrysler300/

<*> To unsubscribe from this group, send an email to:
    Chrysler300-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/