Re: [Chrysler300] 1964 300K crossram brakes

[mwl1967@xxxxxxx]

In a message dated 10/15/2005 1:48:01 P.M. US Mountain Standard Time,  
crockww@xxxxxxxxx writes:

Hi  everyone: I am having a problem with the brales on my 300K. I have a new  
master cylinder. When the peddle is pressed it becomes firm and will not  
release. If I bypass the hydro vack I have brakes but not very good. Wheel  
cylinders are ok. 
This is beyond me so if anyone has had this problem and  solved it or any 
suggestions I will be very appreciative.
Thanks Walter  Beesley



If this occurred immediately after you replaced your master cylinder your  
new master probably has a residual check valve built into it. You'll probably  
have to pull the master, disassemble, remove the check valve and  reassemble.
 
If the problem occurred prior to your replacing the master then the problem  
is in the hydrovac.
 
Mike Laiserin\
Phoenix, Az


[Non-text portions of this message have been removed]



------------------------ Yahoo! Groups Sponsor --------------------~--> 
Get fast access to your favorite Yahoo! Groups. Make Yahoo! your home page
http://us.click.yahoo.com/dpRU5A/wUILAA/yQLSAA/8LmulB/TM
--------------------------------------------------------------------~-> 

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Chrysler300/

<*> To unsubscribe from this group, send an email to:
    Chrysler300-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/