Re: {Chrysler 300} Ball & trunnion u-joint for F?

Andy Birnbaum has the kit, does not include c.i. housing.

Gary The Parts Doc

From: 'Randal Edison' via Chrysler 300 Club International

Sent: Monday, October 13, 2025 12:56 PM

Subject: {Chrysler 300} Ball & trunnion u-joint for F?

Hi all,

After checking the u-joints on my F, per a recommendation from Gloria, it appears the ball & trunnion u-joint is getting loose.

I did a quick Google search and found a few sources for rebuild kits, but wanted to see if anyone had a recommendation on any particular source over another?

I did check the club tech page and saw Bob's video on replacing the boot, as well as John's instructions on replacing the driveline with a modern slip spline driveshaft. Any insights/advice on doing this repair, or replacing with the updated driveshaft, would be much appreciated👍

Thank you,

Randy

F in WY...where the lows r starting to hit the freezing mark!🥶

Yahoo Mail: Search, Organize, Conquer

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/474747731.2085321.1760385407276%40mail.yahoo.com.