{Chrysler 300} Vapor barriers

["'ALLAN POZDOL' via Chrysler 300 Club International" <chrysler-300-club-international@xxxxxxxxxxxxxxxx>]

I could use a little confirmation on the moisture barriers on my K.

 

It appears that the bottom edges tuck into the door along a slot at the bottom and are held in place and sealed by the black tape. The rears are a mess.

Not seeing much if any old adhesive sealant on my car.

 

I have to give two thumbs up for the moisture barrier kit from Performance Car Graphics!

 

All four pre-cut plastic pieces fit nicely; many strips of the black tape and a roll of the adhesive putty strips are included. They say there is a string inside like original!

 

I also found the pressed steel clips on the rear panels, and wires on the front. I know clips is clips, but did it come this way from the factory?

 

Allan

-- 
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
--- 
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/1746068955.1108564.1735335638092%40connect.xfinity.com.

Attachment: 20230125_183709_resized.jpg
Description: JPEG image

Attachment: 20230125_183659_resized.jpg
Description: JPEG image

Attachment: 20221226_174350_resized.jpg
Description: JPEG image

Attachment: 20221226_174209_resized.jpg
Description: JPEG image