James, I have the 6”x 9” Retro Sound in my ’65 Barracuda dash built up on a stand for assembly, not yet in car. You may remember seeing it when you were in my shop. The radio has the Aurora conversion in it, and I’ve played it many hours over the last 1-1/2 years while working on the project, with no problems. This dash is very tight, and will not accommodate a 6” x 9” with a big magnet. I’m very familiar with installing two 4” speakers in a 6 x 9 panel and it is a good approach, my 300G currently has that arrangement. Having said that, I like the idea of a dual voice coil woofer with separate L/R tweeters. It provides more bass than two 4” speakers, because the woofer is larger . I was very happy to find a dual voice coil 6 x 9 that fit. I’ve been an audio buff since my early 20’s, and recognize that debating speakers is a bit like politics, there are a lot of opinions. You may want to try a couple different setups and see what works best for you; in terms of fit, and sound quality. I buy a lot from Amazon, and I’m not shy about retuning things that don’t satisfy my needs. Bob J From: 'James Douglas' via Chrysler 300 Club International <chrysler-300-club-international@xxxxxxxxxxxxxxxx>
Sent: Sunday, December 8, 2024 8:46 AM
To: John W Sager <cleanthegarageout2@xxxxxxxxx>; Ryan Hill <ryan_hillc300@xxxxxxxxxxx>
Cc: chrysler-300-club-international@xxxxxxxxxxxxxxxx
Subject: RE: {Chrysler 300} Front Speakers - 1965 John, Can you elaborate on the failure of the Retrosound Speakers? Has anyone else had any issues with them? James Ryan, I don't want to muddy the waters either about the L vs. the K so this is good. . The front speaker I took out of my L is a 6x9 as is the rear. While both were replacement Radio Shack 6x9, if you look up under the dash, the opening is is for a 6x9. FWIW, the front speaker in my '65 Barracuda is also a 6x9 and I took the original speaker out of that one. The mounting brackets are the same as the picture. With my '70 300 convertible, the front speaker is a 4x10.and the rear is a 6x9. I use a plate I made for two 3" speakers for the front and a Customsound 6x9 in the rear with the Aurora conversion. It was suggested to use a lower profile Retrosound speaker, but my experience with two dismal failures of Retrosound speakers within a year of installing them just doesn't ,make me want to give them any more money. Yes, those speakers were correct ohm rating and were not overpowered. This is what I made for my 300L front. 4" Alpine speakers. I haven't wandered out to the cold garage to bolt it into the car yet, but it should be OK. John, I don’t want to muddy the waters too much about 1965’s on a 300K thread, my original response was to suggest making a mount to attach two small right and left speakers in the single speaker position. To be clear though, the front speaker opening on my 1965 300 and several others I’ve seen is 4 X 10. I think they had an adapter bracket that allowed for the use of a 6 x 9. It’s been more than 20 years since I had my eyes on the installed speaker panel but I still have the original 4 x 10 in a box here. My car had the two speaker system with reverb. Attached is a picture of a 6 X 9 with the adapters taken from a c-body forum. The front speaker for the 300L is 6x9. I'm just finishing up a plate to mount two 4" Alpine speakers. For my front speaker on my ’65 I made a mounting panel the same dimension as the original speaker, which I recall was 4” x 10”. I cut two speaker holes in the plate and mounted small Rockford Fosgate speakers to it. It sounds great and avoided the cost of custom speakers. Rear are 6” x 9” and bolt up directly under the package tray.
--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/658448698.377913.1733606728483%40mail.yahoo.com. --
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/CY5PR19MB6171FDBD71EA92819457DF4A93332%40CY5PR19MB6171.namprd19.prod.outlook.com.
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/01e301db49ab%24d6b82830%2484287890%24%40comcast.net.
|
